Your water heater is one of the most used and much more costly appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating and costs.
Regular flushing of your water heater are probably the single most important step you get to prolong its service life this particular save energy. During time, sediments strengthen in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most associated with the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double daily life of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is vital in today’s economy. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.
To drain your water heater, on the internet should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located over the water inlet line going into your water heater. You can then connect a hose to the drain valve located in the bottoom of the central heater. Open the drain and allow it to play until all of the water has emptied from the heating unit. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until water flows out smoothly. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and products to suit your needs.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX